Knowledgebase
Filmex Screen Protectors > Filmex Help Desk > Knowledgebase

Ask a question:


How to apply screen protectors

Solution

 Make sure you apply screen protectors in dust-free area!

1. Use the supplied cloth to clean the screen surface of fingerprints. To remove the dust use the dust-removal sticker provided.

2. Pull sticker tab No.1 downwards until 1-2cm of the adhesive side is exposed.

3. Apply the adhesive area to your device screen. When it's aligned, pull away the remainder of the disposable layer, while simultaneously applying protector using the smoothing card provided.

If the bubbles appear - Stop applying!

If the bubbles is a result of trapped air:
- Lift screen protector until bubbles removed, then re-apply the area

If the bubbles is a result of trapped dust (these appear as bubbles with "dots" inside them):
- Lift screen protector and using removal sticker remove the dust specks

4. Pull sticker tab No.2 downwards to remove the final disposable layer

 

If you need to lift Filmex screen protector for any reason, we hightly recommend to use re-install labels provided. This prevent damage and very importantly allows you to avoid touching adhesive side of the screen protector.

 

Youtube videos:
Dry fitting - http://www.youtube.com/watch?v=euIPR-yTZrE
Wet fitting - http://www.youtube.com/watch?v=l-7bXUa4V5o

 

 
Was this article helpful? yes / no
Article details
Article ID: 1
Category: How to apply screen protectors - Multilanguage
Date added: 2012-06-04 14:31:31
Views: 726
Rating (Votes): Article rated 4.5/5.0 (8)

 
« Go back

Copyright 2012 | FILMEX. All Rights Reserved